T-Stop für VA 10

T-stop made of nickel-plated brass for the Varga VA10 table saw, used as a precise end stop for accurate saw blade positioning in the guide rail.

>

Application: T-Stop for the Saw Blade in the Guide Rail

>

Suitable for: VA 10

>

Product Type: Spare Part

Product Number: 70-10-4006

T-Stop für VA 10

The T-stop, made of nickel-plated brass, is a spare part for the Varga VA10 table saw and serves as a precise end stop for the saw blade within the guide rail. It ensures exact blade positioning, supporting clean and repeatable cuts. The T-stop is glued into the guide rail and must then be re-cut. For correct installation, it is important to follow the corresponding instructions.

Technical Specifications:

Suitable for: VA 10
Dimensions: 45 x 10 x 4 mm (1.77 x 0.39 x 0.16 in)
Weight: 11 g (0.024 lbs)

Manufacturer

VARGA SYSTEM GmbH

Hainkämpe 5
28832 Achim
Germany
Email: info@varga-system.com

Warnings

The T-Stop may only be installed or replaced when the table saw is completely switched off and disconnected from the power supply. Improper installation or use can lead to malfunctions, damage to the machine or injury. Do not use the T-Stop if it is damaged, bent or loose. The T-stop is intended exclusively for use with the Varga VA 10 table saw and must not be used in other machines.

Safety Instructions

Before commissioning, check that the T-stop has been correctly glued in place and cleanly recut. Use only original spare parts to ensure the precision and safety of the machine. After assembly, carry out a test run with appropriate safety measures to confirm correct operation.

Intended Use

The T-stop serves as a precise end stop for the saw blade in the guide rail of the Varga VA 10 table saw and ensures exact positioning for clean, repeatable cuts.