Right Stop, Complete for VA 11

Adjustable right stop with spring return for the Varga VA 11 table saw, for guiding workpieces up to 300 mm wide.

>

Application: Precise Workpiece Positioning

>

Suitable for: VA 11

>

Product Type: Spare Part

Product Number: 70-11-50025

Right Stop, Complete for VA 11

The adjustable right stop with spring return is a spare part for the Varga VA 11 table saw. The rigt stop is used for workpieces up to 300 mm (11.81 in) wide. When using the rear stop (stop 2), 10 mm must be added to the scale value in order to determine the correct measurement. The front stop (stop 1), on the other hand, allows the scale value to be read directly without correction.

Technical Specifications:

Suitable for: VA 11
Dimensions: 475 x 34 x 37 mm (18.70 x 1.34 x 1.46 in)
Weight: 602 g (1.33 lbs)

Manufacturer

VARGA SYSTEM GmbH

Hainkämpe 5
28832 Achim
Germany
Email: info@varga-system.com

Warnings

The stop may only be mounted, adjusted or replaced when the device is switched off and disconnected from the mains. During sawing, there is a considerable risk of injury from the rotating saw blade and moving machine parts. The stop must not be altered, bent or tampered with, as this can lead to malfunctions and a loss of operational safety.

Safety Instructions

Before each use, ensure that the stop is correctly mounted, securely locked in place and can move freely. After sawing, the stop should be returned to its original position and the function of the spring return checked. Only original spare parts or components approved by the manufacturer may be used to ensure compliance with safety requirements.

Intended Use

The adjustable stop with spring return is used for precise and safe guidance of workpieces on the Varga VA 11 table saw. It enables stable support and accurate dimensional guidance when sawing workpieces up to 300 mm wide.